Re: Sanding round prop spars

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

From: Ronald Williams <groncan_at_gmail.com>
Date: Mon, 4 Nov 2013 14:46:51 -0500

It’s possible to make a tapered v groove by planing opposite edge corners of two boards and then gluing the boards together to form the groove. Another possibility is using a chamfer bit in a router, setting up to make a tapered cut on a router table.
Received on Mon Nov 04 2013 - 11:46:54 CET

This message: [ Message body ]
Next message: mkirda_at_sbcglobal.net: "Re: Sanding round prop spars"
Previous message: Nick Ray: "Re: Re: Sanding round prop spars"
Maybe in reply to: Neil Dennis: "Sanding round prop spars"

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:48 CET