Re: Sanding round prop spars

From: <mkirda_at_sbcglobal.net>
Date: Mon, 04 Nov 2013 20:16:38 -0000

Hi Nick.

It could if the blade has the right tooth angles. Actual 90 degree angles are rare in saw blades. In my case, I'd rather work with my router table if possible as it is easier to control the dust/chips.

You can also scrape at the groove with a sharp chisel or even xacto blade, but that is pretty labor intensive.

Regards.
Mike Kirda

--- In Indoor_Construction_at_yahoogroups.com, Nick Ray <lasray@...> wrote:
>
> Maybe you could accomplish the same thing by setting up a shimmed block and
> running it through a table saw with the blade set at 45 degrees?
>
>
> On Mon, Nov 4, 2013 at 2:20 PM, William Gowen <wdgowen_at_...> wrote:
>
> >
> >
> > How about a countersink bit?
> >
> > On 11/4/2013 12:45 PM, mkirda_at_... wrote:
> >
> >
> >
> > Anyone have recommendations on a router bit that will actually make a
> > sharp V? I have three bits and not one of them make a sharp V. All leave a
> > bit of rounded material at the bottom.
> >
> > Regards.
> > Mike Kirda
> >
> >
> >
> >
>
Received on Mon Nov 04 2013 - 12:16:40 CET