Re: Re: Sanding round prop spars

From: Nick Ray <lasray_at_gmail.com>
Date: Mon, 4 Nov 2013 14:43:16 -0500

Maybe you could accomplish the same thing by setting up a shimmed block and
running it through a table saw with the blade set at 45 degrees?


On Mon, Nov 4, 2013 at 2:20 PM, William Gowen <wdgowen_at_gmail.com> wrote:

>
>
> How about a countersink bit?
>
> On 11/4/2013 12:45 PM, mkirda_at_sbcglobal.net wrote:
>
>
>
> Anyone have recommendations on a router bit that will actually make a
> sharp V? I have three bits and not one of them make a sharp V. All leave a
> bit of rounded material at the bottom.
>
> Regards.
> Mike Kirda
>
>
>
>
Received on Mon Nov 04 2013 - 11:43:17 CET