Rib slice tool - update

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

From: <mkirda_at_sbcglobal.net>
Date: Sat, 20 Oct 2012 19:20:29 -0000

I have ordered enough for 20 units. I will likely use stainless steel pan head screws rather than countersink them, one less step that would increase the cost.

I should have them in hand around Nov. 1st. I will post pictures before accepting any orders.

Regards.
Mike Kirda
Received on Sat Oct 20 2012 - 12:20:32 CEST

This message: [ Message body ]
Next message: mkirda_at_sbcglobal.net: "Urbana (Unofficial) results"
Previous message: Mark F1diddler: "Re: Local sources for .006 - .009" music wire?"
In reply to: N. A. Monllor: "RE: Re: Rib slice tool"
Next in thread: John Barker: "Re: Rib slice tool [1 Attachment]"

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:47 CET