I went through the scrap box, and actually many of the pieces are about 4"
x 12". I will cut them down to fill an 8.5" x 11" bubble mailer. One
bubble mailer filled with this foam should be a lifetime supply for anyone
making composite screw blocks. Shipping in the US should only be a few
dollars.
On Tue, May 23, 2017 at 1:50 PM, Jake Palmer <82.jake_at_gmail.com> wrote:
> We use Gurit M80 composite foam where I work, and we're getting ready to
> scrap a lot material that's too small for use in our products. Most of the
> pieces are 4"-6" wide and 4"-6" long. It's all 5/8" thick. This foam
> isn't quite as good from a specification standpoint as Rohacell, but I've
> successfully made and used composite screw blocks with it in the past. For
> those that are curious I've attached a data sheet.
>
> Anyone that's interested in getting some of this foam should contact me
> ASAP. I'll send it to anyone that's interested for just the cost of
> shipping. I've only got 24 hours to take what I want before the rest is
> scrapped, so contact me immediately if you want some. Even if you aren't
> ready to build a composite VP hub right now, it's not a bad idea to get
> this foam now because you can't beat the price.
>
> Jake
>
Received on Tue May 23 2017 - 21:51:49 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:48 CET