"Lower than yo' mamas ever seen it in her lifetime"
(apologies to Luda)
Picture in the "Rubber" album in the Photos section:
http://groups.yahoo.com/group/Indoor_Construction/photos/album/16487077/pic/list?mode=tn&order=ordinal&start=1&dir=asc
I experimented w/ the Geauga rubber stripper tonight. Cutting off the right side (inside face) I got down to .005" with a .010" lip on one side.
Then, by accident, I found that the left side (outside face) could go even lower: It sliced off a wedge about 1/3 the height of the strip, .005" lip, .0025" in the center, fading off to nothing on the other side.
Joshua, email me your mailing address and I'll send it to you. Figuring out how to tie it, wind it, and get it on your model is on you :)
Received on Thu Mar 17 2011 - 22:20:21 CET