That's the dial gage with the extra strong spring, right?
Ray
--- In Indoor_Construction_at_yahoogroups.com, "John Kagan" <john_kagan@...> wrote:
>
> "Lower than yo' mamas ever seen it in her lifetime"
> (apologies to Luda)
>
> Picture in the "Rubber" album in the Photos section:
> http://groups.yahoo.com/group/Indoor_Construction/photos/album/16487077/pic/list?mode=tn&order=ordinal&start=1&dir=asc
>
> I experimented w/ the Geauga rubber stripper tonight. Cutting off the right side (inside face) I got down to .005" with a .010" lip on one side.
>
> Then, by accident, I found that the left side (outside face) could go even lower: It sliced off a wedge about 1/3 the height of the strip, .005" lip, .0025" in the center, fading off to nothing on the other side.
>
> Joshua, email me your mailing address and I'll send it to you. Figuring out how to tie it, wind it, and get it on your model is on you :)
>
Received on Fri Mar 18 2011 - 05:56:28 CET