> I tend to use a brute force approach to sizing motors for the events
> that I fly. My F1L motors have been creeping up into the mid-.060 range.
> I was wondering if anyone would want to share info about the sizes
> they've had success with in high ceilings?
Bill san,
I do not know the rubber width at all because I have never measured the
width of rubber.
I have used 260 to 275 mg/ 10cmLoop (= 1.30 to 1.38 g/m) in high ceilings
and 270 to 300 mg/ 10cmLoop in low ceilings for my F1Ls.
Good flying, Aki
Received on Fri May 11 2007 - 08:22:00 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:45 CET