Who sell that kit and does it cost?
On Wed, Oct 31, 2018, 3:16 PM joshuawfinn_at_gmail.com [Indoor_Construction] <
Indoor_Construction_at_yahoogroups.com> wrote:
>
>
> Don,
>
> I don't know what level of relevance this provides, but there was a
> discussion about preassembled parts for outdoor models or something of that
> nature about 5 (probably closer to 10) years ago (hopefully Don DeLoach can
> weigh in on this with a better memory than mine). It was specifically for
> AMA competition, so there again, not necessarily relevant.
>
> [Personal opinion segment]
>
> One of the major problems at hand is that BOM as originally envisioned
> never anticipated the proliferation of DIY equipment and the like, and
> certainly not the level of factory quality machining equipment that would
> come into play even as early as the 1970s. A look at the machining involved
> in the gas models in AMA's old "Adrift on the Air" really serves as an eye
> opener to the gap that existed between those who had access to that
> equipment and those who didn't. Indoor has remained insulated from that
> situation to at least a reasonable extend for quite some time, but that
> insulation seems to be fading.
>
> I'm partly fearful of what will happen when BOM is lifted from indoor,
> but it probably won't make any major changes, just as it has had zero
> effect in AMA outdoor flying.
>
> [/Personal opinion segment]
>
> -Josh
>
>
>
>
Received on Wed Oct 31 2018 - 16:52:17 CET
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:49 CET