Kurt
Can you share the adhesive you used please??
Best regards
Simon​
On 22 October 2017 at 14:53, Kurt Krempetz krempetz_at_yahoo.com
[Indoor_Construction] <Indoor_Construction_at_yahoogroups.com> wrote:
>
>
> I am not aware of any one selling carbon rods this small in
> diameter. The smallest protruded carbon fiber rod that I found is .010" in
> diameter (.25mm).
>
> I have make some small diameter carbon rod about this diameter, by getting
> some 1K carbon fiber tow, saturate it with glue and hang it vertically with
> some small weight at the end, twist it up,(locking it from rotating) and
> letting it cure. This method produced some .002-.003" (.05-.07mm)diameter
> rods(tolerances were poor) with a glue to carbon ratio that was high(60%
> glue), so the rods did not have as good of mechanical properties as a
> protruded rod.
>
> Cheers,
> Kurt
>
>
> ------------------------------
> *From:* "Roy White roytigerwhite_at_yahoo.com [Indoor_Construction]" <
> Indoor_Construction_at_yahoogroups.com>
> *To:* "Nick Ray lasray_at_gmail.com [Indoor_Construction]" <
> Indoor_Construction_at_yahoogroups.com>
> *Sent:* Saturday, October 21, 2017 7:10 PM
> *Subject:* Re: [Indoor_Construction] Re: where to get contest grade
> indoor wood.
>
>
> were can i buy .050mm carbon rods Roy
>
> On Friday, October 20, 2017, 8:22:58 AM CDT, Nick Ray lasray_at_gmail.com
> [Indoor_Construction] <Indoor_Construction_at_yahoogroups.com> wrote:
>
>
>
> Edmund,
>
> I sent you a PM. If anyone else needs the address feel free to contact me
> off list.
>
> All the best,
>
> Nick
>
> On Thu, Oct 19, 2017 at 10:01 PM, eliem_at_vedderdental.ca
> [Indoor_Construction] <Indoor_Construction_at_yahoogroups.com> wrote:
>
>
> Thanks Nick, but indeed, yahoo cutoff the email.
> Try again, but spelled out.
> Edmund
>
>
>
>
>
>
--
Best regards
Simon Bargery
Received on Mon Oct 23 2017 - 10:11:24 CEST