Re: Getting best results from the Oppegard rubber stripper

From: <mkirda_at_sbcglobal.net>
Date: 29 Jul 2015 09:50:19 -0700

Hi Fred.

No, that would not have been me. It was just something I tried out early in this process and it was more consistent for me at that point and I continued that way up to the point I stopped cutting test strips.
Maybe it matters, maybe it doesn't. {shrug} That is the reason I figured I would ask.

The TanSS I am using is really trapezoidal in the cut, 15-20 degrees. My Oppegard also cuts at an angle, but not as severe, maybe 5-10 degree range by eyeball. It is pretty difficult to measure 'width' of a trapezoid.

Regards.
Mike Kirda
Received on Wed Jul 29 2015 - 09:50:23 CEST