Mike,
I found the little blocks glued onto the wing spar to work the best.
Jeff
--- In Indoor_Construction_at_yahoogroups.com, "mkirda@..." <mkirda@...> wrote:
>
> Back in the day when I built a 65cm F1D, I recall there being two methods of bracing.
> 1) Slice the spar slightly and use the slice to hold the wire.
> 2) Glue on a bit of say 1/32" square and use that to hold the wire.
>
> I seem to recall using #2 as I had failures when I went the spar slicing method.
>
> Given that these stand proud, is there any issue when steering?
> Do they tend to catch on the foam or are they small enough to not make a difference?
>
> Regards.
> Mike Kirda
>
Received on Wed May 15 2013 - 19:15:17 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:47 CET