--- In Indoor_Construction_at_yahoogroups.com, "Mark F1diddler" <f1diddler@...> wrote:
So yes here's a little problem, and here I need suggestions for better defining a BOM intention consistent with the rest of it.
Thanks,>>
However "the rest of it" means that pre-cut/shaping of any individual component is allowed. So maybe not possible (with consistency) to limit carbon at any stage of reworking, since it's always part resin, "adhesive" being the defining hinge for everything else.
MB
Received on Tue Oct 23 2012 - 12:18:52 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:47 CET