rubber stripper
________________________________
From: joshuawfinn <jwfinn_at_lycos.com>
To: Indoor_Construction_at_yahoogroups.com
Sent: Tue, March 15, 2011 4:28:12 PM
Subject: [Indoor_Construction] Re: How small can you go?
Ignacio, I've tried flying it in a decent Cat II site, but keep hanging up. I
don't have access to any really good sites. We've got a Cat III on campus, but
it has terrible drift.
Good, thin rubber would be very welcome. I really want to know how I can do it
myself, of course, but I haven't received any comments of that nature.
-Joshua
--- In Indoor_Construction_at_yahoogroups.com, "izgo" <izgo_at_...> wrote:
>
>
> Joshua,
>
> Wonderfull!! I love P-25.
>
> 5+ minutes can be done in a cat-II place where you can touch. My better times
>is with motor about 40cm (16") long and weights 1.2 grams. Loading 2400 turns.
>
> On the 0.005" rubber i have to check if i have some. Because I saved a lot o
>lateral cuts (a pre cut) done into used wakefield used motors. If I have
>something close I can mail you some rubber.
>
> Ignacio.
>
>
>
>
> --- In Indoor_Construction_at_yahoogroups.com, "joshuawfinn" <jwfinn_at_> wrote:
> >
> > Ignacio,
> >
> > Yes, I do have an Argentine P-25 (my own design) which is double covered and
>features full geodetic construction. It's a good plane; flew right off the board
>with nary a bad habit, other than needing a lot of ballast to make the minimum
>weight. I need to get it back...it's about 35' up stuck to the ceiling of an
>indoor tennis court right now. Try as I might, I can't get it past 3 minutes,
>mainly because it keeps running into things. Maybe I'll take it to a higher site
>sometime and get it to fly for real.
> >
> > -Joshua
> >
> > --- In Indoor_Construction_at_yahoogroups.com, "izgo" <izgo_at_> wrote:
> > >
> > > Hi Joshua,
> > >
> > > Very nice! Hard to cut rubber at that size for the little plane.
> > >
> > > Also saw other videos in your channel and I found 3 about "P-25". I'm just
>curious abut if those models are the same as described in folder Argentina nats
>- P25 rules?
> > >
> > > Ty, Ignacio.
> > >
> > >
> > >
> > > --- In Indoor_Construction_at_yahoogroups.com, "joshuawfinn" <jwfinn_at_> wrote:
> > > >
> > > > This was an experiment to see just how far such a thing could be pushed.
>Apparently it can be pushed further. Anyone know how to strip rubber down to
>.005"?
> > > >
> > > > http://www.youtube.com/watch?v=XI0x6DPxWYg
> > > >
> > > > Enjoy!
> > > >
> > > > -Joshua
> > > >
> > >
> >
>
Received on Tue Mar 15 2011 - 18:51:41 CET