Oppeguard rubber stripper

From: James <flyerj66_at_yahoo.com>
Date: Mon, 11 Oct 2010 06:12:09 -0000

Hi All,
I just obtained a used Oppeguard rubber stripper, that leaves sections of rubber totally uncut. The uncut sections vary in length from a fraction of an inch to a couple of inches or a little more, as well as the rate of recurrance. The crank handle has a very slightly noticeable tightening at one certain point in it's rotation but as I say, it's barely detectable, & since the blades rotate at different speeds, does this indicate a blade with a dull spot or perhaps a blade with a warped area? Has anyone else ever ran into this with an Oppeguard? & does anyone know of a fix or how to get it repaired?

Thanks,
     James Strickland
Received on Sun Oct 10 2010 - 23:12:11 CEST