Cool-- thanks!
Another newbie question. I noticed lots of people are posting their motor sizes using a length and weight in grams as you did below. How do you cut a motor to a gram size, as opposed to setting a stripper to a certain width?
KT
--- In Indoor_Construction_at_yahoogroups.com, "Bill Gowen" <wdgowen@...> wrote:
>
> It will depend on your prop and the weight of your model. I use about 18" x 1 gram which is in the neighborhood of .050".
>
> ----- Original Message -----
> From: jabiruchick
> To: Indoor_Construction_at_yahoogroups.com
> Sent: Tuesday, April 27, 2010 12:01 PM
> Subject: [Indoor_Construction] A-6 Motors
>
>
>
> Hi Guys,
>
> I'm ordering some supplies for the USIC and wondering about what size rubber I should start with for A-6. I built Gary Hodson's Wart with the lightest wood I have and Gampi tissue, but have no idea what it weighs because I don't have a gram scale. It's my first try at A-6 and my first try at any true duration models for about 15 years, since I was a kid fooling around with Parlor Mites & EZBs.
>
> Any suggestions for a good beginning range of motor thicknesses in inches?
>
> Thanks!
> Katie
>
Received on Tue Apr 27 2010 - 11:42:30 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:46 CET