Re: Label for rubber envelope [1 Attachment]

From: Fred or Judy Rash <frash_at_chartertn.net>
Date: Tue, 20 Apr 2010 20:51:45 -0400

Thanks, Bill, for all the helpful information, build logs, plans, and
other helpful indoor modeling methods.

I have been using, but have run out, of Micro-X motor envelopes that are
white 3-in * 4 7/8-in or "3 by 5". Your label for envelopes approach may
get me out of plastic bags and to a better system.

Fred Rash

On 4/20/2010 6:25 PM, Bill Gowen wrote:
> [Attachment(s) <#TopText> from Bill Gowen included below]
>
> I use the 2 1/2" x 4 1/4" manila coin envelopes for my motors. Over
> time I've collected a bunch of motors and they have all different
> kinds of notes scribbled on them. I decided it would be nice to have
> some sort of standardized notation and that either preprinted
> envelopes or labels for this information would be great.
> I found a container of Avery #8163 2" x 4" shipping labels that looked
> just right for the job. The problem was that using the standard label
> formatting in Open Office didn't permit a landscape layout for the
> sheet that would let me print the labels in a vertical orientation to
> fit the envelopes. After much fiddling I got a table made that would
> let me do this. The attached picture is the result.
> I'll put the master document in the files section in case anyone else
> wants to play with it.
>
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.801 / Virus Database: 271.1.1/2823 - Release Date: 04/20/10 08:45:00
>
>
Received on Tue Apr 20 2010 - 17:51:55 CEST