I wouldn’t mind seeing produce film become the only plastic allowed. I
don’t care what kind of plastic keeps the moisture out of my models just so
they don’t have to go from this usually near 100% relative humidity to the
much dryer air in the mountains of Eastern Tennessee. I’ve mentioned that I
think plastic is easier to apply but my main reason for hoping to see it in
A-6 is the instability of Condenser Paper.
It’s raining here. Does that mean the RH is 100%?
Ken
From: Indoor_Construction_at_yahoogroups.com
[mailto:Indoor_Construction_at_yahoogroups.com] On Behalf Of Bill Gowen
Sent: Thursday, February 04, 2010 10:12 AM
To: Indoor_Construction_at_yahoogroups.com
Subject: Re: [Indoor_Construction] New poll for Indoor_Construction
Don
I think it would be a good idea to redo your set of rules using a current
event like LPP or EZB as a model. You could preserve the entire set of rules
that you want and eliminate some of the ambiguities that people are bringing
up - like torque burners, biplanes, etc.
If your final rules set okays plastic covering then I would encourage a
second vote on what type of plastic would be allowed. While I mostly
disagree with Gary's position I think disallowing specialty indoor films
would avoid the problem of giving new models an advantage. Gary could keep
flying the paper covered models that he loves and still probably beat the
rest of us.
----- Original Message -----
From: Indoor_Construction_at_yahoogroups.com
To: Indoor_Construction_at_yahoogroups.com
Sent: Thursday, February 04, 2010 3:25 AM
Subject: [Indoor_Construction] New poll for Indoor_Construction
Enter your vote today! A new poll has been created for the
Indoor_Construction group:
I have submitted A-6 as an official AMA event for inclusion in the 2011
rulebook, with some minor tweaks. Please weigh in with your opinion on these
two issues. If you have active indoor FF friends who are not members of
Indoor_Construction please have them contact me, Don DeLoach, at
719-964-7117 or ddeloach_at_comcast.net <mailto:ddeloach%40comcast.net> . My
complete, official A-6 proposal cam be seen at
http://www.modelaircraft.org/events/ruleproposals/indoorff.aspx.
Do you support allowing plastic covering in A-6?
Do you support limiting the stabilizer to 50% of wing area?
o Yes to plastic covering ONLY
o Yes to 50% stab limitation ONLY
o Yes to both
o No to both
To vote, please visit the following web page:
http://groups.yahoo.com/group/Indoor_Construction/surveys?id=2270287
Note: Please do not reply to this message. Poll votes are
not collected via email. To vote, you must go to the Yahoo! Groups
web site listed above.
Thanks!
Received on Thu Feb 04 2010 - 16:41:24 CET