A6 to become new AMA event ?

From: Mark F1diddler <f1diddler_at_yahoo.com>
Date: Sat, 30 Jan 2010 15:23:13 -0000

A6 flyers,
 
The new A6 rule set reportedly submitted to AMA by Don DeLoach contains at least two substantive differences with the "2006 A6 Committee" rules (available in InCo Files section.) The DDL new rules copied here below.

Notice the prop rule (#8) where the specification "wood" has been deleted. This would allow use of foam for prop blades or whatever else. To back this up, in his rule #10, the general high tech material prohibition and specific foam prohibition has been deleted, compared with 2006 A6 Committee rule set.

Also notice rule #2--a new thing for A6--where tail area is limited to 50% Some of you would need new stab.

For all I know, many affected A6 flyers have been contacted by DDL for collaboration, input, feedback about this new rule set. IF SO, please enjoy your new A6. (PS, it takes two rounds of AMA voting, so this won't happen overnight.)
JMO,
Mark F1diddler


A6 rules reportedly submitted to AMA for event status:

<<1. Maximum projected wing area: 30 square inches.

2. Maximum projected stabilizer area: 15 square inches.

3. All wing and stab outlines shall be 1/16: square minimum, corners left square/unsanded.

4. Wing posts 1/16 square (ends may be rounded for inserting into paper tubes).

5. Motor stick: 6” long maximum (measured from the front thrust bearing face

to the front of the rear hook).

6. Cambered ribs are acceptable but must be cut from 1/32” balsa sheet. Rib depth must be 1/16" minimum.

7. Weight: 1.2 grams minimum without rubber.

8. Propeller 6 inch maximum diameter. Blades to be flat 1/32 sheet. (No camber/forming). No thinning of blade thickness and all edges must be left square.

9. Covering: Tissue, condenser paper, or gampi paper - no plastic.

10. No boron or carbon may be used.>>
Received on Sat Jan 30 2010 - 07:23:24 CET

This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:45 CET