Hi Group, Since these are D.C. Motors, I presume that it must be a brush
type. It
should be possible to attach a "S" hook to the shaft with a collar and set
screw.
Since Brush type D.C. motors will generate electrical power and current by
mounting the motor assembly to the "TEST" assembly using rubber motors
attached to a fixed prop shaft, it should be possible to read the generated
values. I hope.
mike k
Received on Mon Apr 30 2007 - 13:30:22 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:45 CET