Speaking of carbon tubes, I will soon be offering pultrusion carbon/epoxy
tubes from DPP that starts at 0.7mm (0.027") OD with a 0.28mm (0.011") ID
and going up to 3.0mm OD. These are thinner wall and smaller diameter than
what is produced by the USA supplier that I carry. Due in about mid June
2006.
Tim
[Denver, CO]
Jones design balsa stripper now available!!
Indoor balsa wood & supplies
Now carrying Carbon Plate, rod, tube, and strip.
www.F1D.biz/order
Indoor flying info
www.IndoorDuration.com
> -----Original Message-----
> The .026" solid carbon leading edges of the previous version
> have been replaced by .038" carbon tubes. With a lot of
> sanding the tubes weigh the same as the rods but have about
> 1/4 the deflection. TE's had to have boron to get a stiffness
> match with the LE's.
>
> I think this is the stiffest indoor model I've ever built!
> Bill Gowen
> Decatur, GA USA
>
>
>
>
>
>
> ------------------------ Yahoo! Groups Sponsor
> --------------------~--> Everything you need is one click
> away. Make Yahoo! your home page now.
> http://us.click.yahoo.com/AHchtC/4FxNAA/yQLSAA/YRTolB/TM
> --------------------------------------------------------------
> ------~->
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
Received on Thu May 25 2006 - 14:04:50 CEST