sam8.org
On Jun 2, 2017 7:18 PM, "Ron Patten ronald.patten_at_att.net
[Indoor_Construction]" <Indoor_Construction_at_yahoogroups.com> wrote:
>
>
> Jake,
>
> Can I have SAM 8's website and contact info, I seem to have deleted it?
>
> Ron Patten
>
>
> On Thursday, June 1, 2017 8:31 PM, "82.jake_at_gmail.com
> [Indoor_Construction]" <Indoor_Construction_at_yahoogroups.com> wrote:
>
>
>
> [Attachment(s)
> <https://mg.mail.yahoo.com/neo/launch?.partner=sbc&.rand=dgvtpr0qpi8bg#TopText>
> from 82.jake_at_gmail.com included below]
> It sounds like they will need to rent a lift to get this done, but it
> might still happen. SAM 8 made a generous donation again this year, and
> that may be enough to cover the extra cost. I should have a better answer
> by next week.
>
> Sent from Mail <https://go.microsoft.com/fwlink/?LinkId=550986> for
> Windows 10
>
> *From: *William Gowen wdgowen_at_gmail.com [Indoor_Construction]
> <Indoor_Construction_at_yahoogroups.com>
> *Sent: *Thursday, June 1, 2017 4:00 PM
> *To: *Indoor_Construction_at_yahoogroups.com
> *Subject: *Re: [Indoor_Construction] Re: Question for Kibbie Dome
> attendees
>
>
> I'm dreaming of bouncing my LPP off the plastic after a full torque launch.
>
> On Thu, Jun 1, 2017 at 5:59 PM, Jake Palmer 82.jake_at_gmail.com
> [Indoor_Construction] <Indoor_Construction_at_yahoogroups.com> wrote:
>
>
> I've made the request to have this plastic sheeting installed on each side
> of the curtain rods. I'll send out a notification once I have a definitive
> answer about whether it will happen.
>
> Jake
>
> On Wed, May 31, 2017 at 4:38 PM, guyettevan_at_yahoo.com
> [Indoor_Construction] <Indoor_Construction_at_yahoogroups.com> wrote:
>
>
> I think this is a great idea. I'd rather my model drop to 120ft than head
> for the wire forest in the center. Thank you Jake for looking into this!
>
> Evan
>
>
>
>
>
>
>
>
>
Received on Sat Jun 03 2017 - 03:13:05 CEST