Greetings.
I made up a few prototype dial-type torque meters.
Apparently they were available in Europe for a short bit around 30 years ago.
These are not for winding, but for verifying settings on VP hub spring settings.
I think that you could also use them for recording torque remaining at the end of a flight.
Would there be interest in this in the greater Indoor community?
I do have a batch of FliteTork digital torque meters I am working on.
The metal work is nearly finished, with one final fabrication step required.
I will be starting final assembly work soon.
Regards.
Mike Kirda
Received on Mon Sep 19 2016 - 13:06:19 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:48 CET