Re: Drill press recommendation for indoor work

From: Jake Palmer <82.jake_at_gmail.com>
Date: Thu, 26 Mar 2015 18:13:04 -0700

What advantage does the higher speed offer? I've been using my regular
floor standing drill press at ~3000 RPM without any problems. I mount the
bit in a pin vise and chuck that in the drill press.
On Mar 26, 2015 4:58 PM, "mkirda_at_sbcglobal.net [Indoor_Construction]" <
Indoor_Construction_at_yahoogroups.com> wrote:

>
>
> When in the Dremel my bits almost disappear, meaning it is out of round.
> Where the point of the bit would touch the material it is tracing a
> circle. It isn't impossible to use, but the results are less than stellar.
>
> My Dumore on the other hand is a far better tool for drilling tiny holes.
>
> Regards.
> Mike Kirda
>
>
Received on Thu Mar 26 2015 - 18:13:06 CET