Re: molding carbon fiber

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

From: <mkirda_at_sbcglobal.net>
Date: 09 Jan 2015 12:00:33 -0800

Hi Neil.

The short answer is No. Just the tension from pulling it lightly. Or a very thin index card works to push it down.

Regards.
Mike Kirda
Received on Fri Jan 09 2015 - 12:00:34 CET

This message: [ Message body ]
Next message: Chuck Etherington: "RE: Re: New hub prototype"
Previous message: Neil Dennis: "molding carbon fiber"
In reply to: Neil Dennis: "molding carbon fiber"

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:48 CET