Re: F1D motor tube stiffness?

From: <mkirda_at_sbcglobal.net>
Date: Mon, 03 Feb 2014 15:30:31 -0000

Good point. Check boron attachment at the bottom of the right wing spar, especially the leading edge. Could be as little as a few mm unattached that could cause this too.

Regards.
Mike Kirda

--- In Indoor_Construction_at_yahoogroups.com, <john_kagan@...> wrote:
>
> Something is loose - most likely the wingpost-to-motorstick joint or the boron attachment to the post. Less likely, the tube attachment to the wing or the boron on the spars. Hold the model by the motorstick and gently twist it torsionally enough to deflect the wing. You'll see the front or back deflect more than the other. Look closely and you should be able to find the culprit. Also, move the model up and down and watch the spars.
>
Received on Mon Feb 03 2014 - 07:30:32 CET