Your CAT 1 CLG Records will be crushed sometime this year! Ciao, Phedon.
--- On Wed, 6/19/13, William Gowen <wdgowen_at_gmail.com> wrote:
From: William Gowen <wdgowen_at_gmail.com>
Subject: Re: [Indoor_Construction] Float Kickstarter
To: Indoor_Construction_at_yahoogroups.com
Date: Wednesday, June 19, 2013, 2:57 PM
I haven't seen the video yet but I agree on thread wrapping the bearing. I've had them come off in my hand with a fully wound motor. If a wrapped one comes loose it usually stays with the motor stick.
On 6/19/2013 10:54 AM, Neil Dennis wrote:
Good morning, Ben: Nice video, I do have a couple comments FWIW. One,
it's kinda dangerous not putting tape on the back edge of the razor
blade, can do a nasty cut. Two, wonder, don't you use a bit of thread
wrap on the front prop shaft mount, at least on the Dennydarts the hook
knocks of pretty easy without the wrap. CA doesn't stick to metal all
that good.
wombat
Received on Wed Jun 26 2013 - 22:16:05 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:47 CET