Re: F1M VP spring question

From: Mark F1diddler <f1diddler_at_yahoo.com>
Date: Fri, 07 Sep 2012 05:19:36 -0000

--- In Indoor_Construction_at_yahoogroups.com, Tapio Linkosalo <tapio.linkosalo@...> wrote:
The spring coil ID is larger than the bearing tubing in the hub (the
former, wound around 1.5mm mandrel is closer to 2mm while the tubing
around the hub shaft is 0.7mm OD). By flipping I mean that the "disk">>


Ok. I had that happen once when trying a different spring. So I just made another centering tube to fit better, meaning just slightly less than spring I.D. Doesn't bother me if spring touches centering tube, as long as it's not jamming against it, which sounds like yours is.
MB
Received on Thu Sep 06 2012 - 22:19:38 CEST