Thanks, Kang.
My most recent stab is 110 mg finished. It's kinda floppy, but doesn't show any warpage under flight loads, which is my primary concern. I could have used better wood than I did, too...
I'm a step ahead of you as far as putting the weight in those places.
-Joshua Finn
--- In Indoor_Construction_at_yahoogroups.com, "Yuan Kang Lee" <ykleetx@...> wrote:
>
> Hi, Josh,
>
> The finished stab frame weighed just under 90 mg. After covering with OS Film, the final weight was 130 mg. At this weight, it's a very sturdy stab.
>
> For a properly built stab, I estimate that the stab frame can weigh just under 70 mg, and the covered stab just under 110 mg. This will be done on the next stab.
>
> I intend to take weight off the stab and wing, and move the weight to the motorstick and VP hub.
>
> -Kang
>
> --- In Indoor_Construction_at_yahoogroups.com, joshuawfinn@ wrote:
> >
> > Kang,
> >
> > What is the weight of your finished stab conversion?
> >
> > -Joshua Finn
>
Received on Thu Jul 19 2012 - 16:00:04 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:47 CET