Re: Re: VP pitch

From: Jake Palmer <82.jake_at_gmail.com>
Date: Thu, 21 Jun 2012 10:51:13 -0700

Dennis,

That's a good point. I was planning to hinge the spars for simplicity, but
I might rethink that and use tubes so I can adjust. Thanks for the info.

Jake

On Thu, Jun 21, 2012 at 10:26 AM, dennisatyson <ddtyson_at_peoplepc.com> wrote:

> **
>
>
>
> Jake,
> Are you hinging the prop spars or are you using tubes and inserting the
> spars? 28 is a good starting point for one of them. The ability to remove
> the blades and re-pitch them is a major plus.
>
> Dennis
>
>
> --- In Indoor_Construction_at_yahoogroups.com, Jake Palmer <82.jake_at_...>
> wrote:
> >
> > I have a question for some of you top F1D guys. I'm building VP props for
> > Kibbie, but I'm not sure what I should use for low pitch. I'm only
> > planning to have adjustment for high pitch, so whatever I build them at
> > will be the low pitch. Any suggestions on a good place to start? I'm
> > building 2 props so I'm planning to make each at a different low pitch to
> > experiment.
> >
>
>
>
Received on Thu Jun 21 2012 - 10:51:15 CEST