Re: Using Boron on outlines.

From: jos_melis <jos_melis_at_yahoo.com>
Date: Thu, 10 May 2012 10:27:20 -0000

--- In Indoor_Construction_at_yahoogroups.com, Tapio Linkosalo <tapio.linkosalo@...> wrote:
>
> On 10.5.2012 9:36, jos_melis wrote:
> > What kind of sidecutter should I buy for cutting the boron? The one
> > I'm using at the moment is not a good one I think.Mainly used for
> > cutting propshafts etc..
>
> I use scissors. Mostly small ones I bought from a fly-tackle shop. I
> take a short piece of office tape, fold it onto the boron to the place
> where I want to cut it, and then cut through the tape. Pull the fibres
> out of the folded tape and put the tape to trash.
>
>
>
>
> -Tapio-
>
Thanks Tapio.
Jos
Received on Thu May 10 2012 - 03:27:21 CEST