Re: Using Boron on outlines.

From: jos_melis <jos_melis_at_yahoo.com>
Date: Wed, 09 May 2012 14:02:11 -0000

--- In Indoor_Construction_at_yahoogroups.com, "Mark F1diddler" <f1diddler@...> wrote:
>
>
>
>
> Jos,
> I received mail failure notice concerning your other question via PM. The notice said <<jos_melis_at_... cannot be delivered. This account has been disabled or discontinued [#102]. >>
>
> ...which doesn't make sense, since you used same account to send? Anyhow, maybe send me an alternate address.
> MB
>
Mark,
I've noticed that there's something wrong with my email adress on yahoo, but I don't understand what :-(
Anyway here's my questtion again.
You put the boron on the sheet before cutting it so: your boron is glued to the sides of the spar??
Or maybe I cut my spars the wrong way :-(( I use a homemadecoppy of the Ray Harlan cutter.

Your advice please and here's my other email adress:
Jos.Melis1_at_telenet.be
Received on Wed May 09 2012 - 07:02:19 CEST