Re: Catapult glider question
Hi Gary,
Sorry to hear your glider had problems. What you are describing can be causes by many things. Launching technique is one. The rubber needs to be stretch perpendicular to the stick, the model needs to be held with the stab/wing parallel to the stretch of the rubber. The hand that is holding the stick must stay still, no motion. Once you hit your hand or stick the tendency is to pull the stick down and away from the model, ....this motion just makes things worse.
Another issue is the hook and whether the rubber can catch or stick on it. The sideways "V" the rubber sits in should have radius, more like a sideways "U" or an upside-down "L", Also I found that metal wire hooks and hooks with little mass to no mass in front of the hook tend to hang up on the rubber.
The typically issue is incidence/flapper. Either incidence was too negative or flappers are too flexible and weak.
I have also seen this happen when the fuse is too weak.
Now moving the hook and hold point to under the wing and at the stab in a model that has these issues will probably make the model not hit the stick but it will also not be a good launch. You will need to adjust/change the other things I mentioned to get a good launch. Once those adjustments are made then the hook and hold point can be forward. A forward hook and hold point allows you to build a lighter model and to get more stretch of the rubber.
I hope this helps. Let's hope the next one flies great.
Kurt
--- On Thu, 8/25/11, Warthodson_at_aol.com <Warthodson_at_aol.com> wrote:
From: Warthodson_at_aol.com <Warthodson_at_aol.com>
Subject: [Indoor_Construction] Catapult glider question
To: Indoor_Construction_at_yahoogroups.com, freeflightml_at_yahoogroups.com
Date: Thursday, August 25, 2011, 8:13 PM
Last year I built my first indoor catapult launched glider. It was sort of based on Kurt Krempet's plans on his web site. It was intended for use in a Cat. 1 or 2 site. After a few horizontal test flights & adjustments I determined it was time to launch it vertically. The first launch it hit the "launching stick" (does that stick have a better name?) & almost destroyed it. After repairs, I tried again. This time it hit the stick again & was completely destroyed. I located the rubber hook near the nose & the grip was located under the wing. I am thinking of building another one this year. I was told I should locate the hook under the wing & the grip behind the stabilizer. What do you think was my problem? Now there is an opening!
Gary Hodson
Received on Fri Aug 26 2011 - 05:50:26 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:46 CET