Phedon is correct in making this suggestion. Bestine rubber cement solvent and thinner is pure heptane. Naphtha and Coleman stove fuel are nearly pure heptane but have a small amount of other hydrocarbons that take longer to evaporate than heptane (thus, Phedon's oily description).
Bestine Solvent and Thinner, which can be found at many art stores, is more expensive than naphtha and Coleman fuel but one can use the Bestine Solvent only to thin the 3M77 and use the cheaper naphtha or Coleman fuel for cleanup.
Leo
--- In Indoor_Construction_at_yahoogroups.com, Phedon Tsiknopoulos <phedon21t@...> wrote:
>
> I would use Bestine and not Naphtha. Bestine is more refined, less oily. Ciao,
> Phedon.
>
>
>
>
> ________________________________
> From: Bill Gowen <wdgowen_at_...>
> To: Indoor_Construction_at_yahoogroups.com
> Sent: Fri, April 22, 2011 9:43:40 AM
> Subject: Re: [Indoor_Construction] covering with mylar
>
>
>
> Kody
> Here's the link to the video. The link back to Mark's article doesn't work.
> http://www.thermalthumbers.com/bill-s-indoor-ramblings/f1l-construction-5-2010/covering-info
>
>
> ----- Original Message -----
> >From: Kody
> >To: Indoor_Construction_at_yahoogroups.com
> >Sent: Friday, April 22, 2011 11:43 AM
> >Subject: Re: [Indoor_Construction] covering with mylar
> >
> >
> >Hey Bill,
> >
> >Could you point me to this video? I'm always interested in alternative methods!
> >
> >Thank you,
> >Kody
> >Sent from my HTC Droid Eris.
> >
> >
> >Bill Gowen <wdgowen_at_...> wrote:
> >
> >>Covering with Mylar is very easy. There are a lot of different ways to do it.
> >>The video you saw is my version of the technique described by F1Diddler in the
> >>files section of this group.
> >>
> >>----- Original Message -----
> >>>From: Edward
> >>>To: Indoor_Construction_at_yahoogroups.com
> >>>Sent: Friday, April 22, 2011 10:42 AM
> >>>Subject: [Indoor_Construction] covering with mylar
> >>>
> >>>
> >>>This is one of the toughest parts of indoor, covering. I was at a web site where
> >>>someone was covering with mylar & was using 3M77 in a "little" plastic container
> >>>mixing it with a solvent and putting it on a stab. with a brush, then it was
> >>>over! It said this process was on Indoor Construction but I cannot find it.
> >>>These guys with the F1Ds that look like they were covered with moulded Mylar
> >>>must be able to leap tall buildings in a single bound! Help.....please.
> >>>Ed Berton
> >>>Brevard, NC
> >>>
> >>>
>
Received on Sat Apr 23 2011 - 06:38:24 CEST