Re: Re: A6 rules proposal

From: Bill Gowen <wdgowen_at_gmail.com>
Date: Fri, 29 Jan 2010 17:35:15 -0500

I have 4.3mg per si for Gitlow light CP.

  ----- Original Message -----
  From: Max
  To: Indoor_Construction_at_yahoogroups.com
  Sent: Friday, January 29, 2010 5:29 PM
  Subject: [Indoor_Construction] Re: A6 rules proposal


    
  I have a stash too, what is super light?

  I measured a sheet (10.95" x 8.4") = 279mg which is around 3mg/1sq inch or 300mg/100sq inches.

  Max

  --- In Indoor_Construction_at_yahoogroups.com, "Bill Gowen" <wdgowen_at_...> wrote:
>
> With that, some 5/99 and some Y2K2 you should be fixed for life!
>
> ----- Original Message -----
> From: Don Slusarczyk
> To: Indoor_Construction_at_yahoogroups.com
> Sent: Friday, January 29, 2010 5:01 PM
> Subject: Re: [Indoor_Construction] Re: A6 rules proposal
>
>
>
> Some good loopholes potential in those rules. With no plastic does this
> mean my secret stash of super light condenser is now worth $100 per sq
> foot :-)
>
> Don S
> > 
> >
> > From Don's proposal:
> >
> >
> > 1. Maximum projected wing area: 30 square inches.
> >
> > 2. Maximum projected stabilizer area: 15 square inches.
> >
> > 3. All wing and stab outlines shall be 1/16: square minimum, corners
> > left square/unsanded.
> >
> > 4. Wing posts 1/16 square (ends may be rounded for inserting into
> > paper tubes).
> >
> > 5. Motor stick: 6� long maximum (measured from the front thrust
> > bearing face
> >
> > to the front of the rear hook).
> >
> > 6. Cambered ribs are acceptable but must be cut from 1/32� balsa
> > sheet. Rib depth must be 1/16" minimum.
> >
> > 7. Weight: 1.2 grams minimum without rubber.
> >
> > 8. Propeller 6 inch maximum diameter. Blades to be flat 1/32 sheet.
> > (No camber/forming). No thinning of blade thickness and all edges must
> > be left square.
> >
> > 9. Covering: Tissue, condenser paper, or gampi paper - no plastic.
> >
> > 10. No boron or carbon may be used.
> >
> >
> > -----
> >
> > *From:* Wart <mailto:Warthodson_at_...>
> >
> >
> >
>



  
Received on Fri Jan 29 2010 - 14:35:22 CET