Re: Re: A6 rules proposal

From: Bill Gowen <wdgowen_at_gmail.com>
Date: Fri, 29 Jan 2010 17:19:38 -0500

With that, some 5/99 and some Y2K2 you should be fixed for life!

  ----- Original Message -----
  From: Don Slusarczyk
  To: Indoor_Construction_at_yahoogroups.com
  Sent: Friday, January 29, 2010 5:01 PM
  Subject: Re: [Indoor_Construction] Re: A6 rules proposal


    
  Some good loopholes potential in those rules. With no plastic does this
  mean my secret stash of super light condenser is now worth $100 per sq
  foot :-)

  Don S
> 
>
> From Don's proposal:
>
>
> 1. Maximum projected wing area: 30 square inches.
>
> 2. Maximum projected stabilizer area: 15 square inches.
>
> 3. All wing and stab outlines shall be 1/16: square minimum, corners
> left square/unsanded.
>
> 4. Wing posts 1/16 square (ends may be rounded for inserting into
> paper tubes).
>
> 5. Motor stick: 6” long maximum (measured from the front thrust
> bearing face
>
> to the front of the rear hook).
>
> 6. Cambered ribs are acceptable but must be cut from 1/32” balsa
> sheet. Rib depth must be 1/16" minimum.
>
> 7. Weight: 1.2 grams minimum without rubber.
>
> 8. Propeller 6 inch maximum diameter. Blades to be flat 1/32 sheet.
> (No camber/forming). No thinning of blade thickness and all edges must
> be left square.
>
> 9. Covering: Tissue, condenser paper, or gampi paper - no plastic.
>
> 10. No boron or carbon may be used.
>
>
> -----
>
> *From:* Wart <mailto:Warthodson_at_aol.com>
>
>
>



  
Received on Fri Jan 29 2010 - 14:19:41 CET