Re: Fwd: Bill Gowen's F1M
Bill,
Thanks for that clarification. I have heard of even numbers of strands, but never odd, before. It seems to me that one knot (as would be required for an even numbr of strands) would use less rubber than two knots (as required with an odd number of srtands).
Gary
No. I really haven't seen a difference. I've had a couple of exceptional 2 strand motors and a couple of exceptional 3 strand motors. These were all about the same length and had about the same characteristics from max turns and torque through the entire unwinding curve. I've also used 4 strand motors that didn't seem to be much different from 2 strand motors.
The 3 strand motors were a 2007 experiment to see if I could use less rubber in the knots compared to a 2 strand motor. I really don't know if they were successful in that regard. What I know for sure is that I hit a really good stretch of 3/02 rubber that produced some outstanding motors. I used a 3 strand motor to do the site record at USIC 2007, a 2 strand one to do the 2007 WR and a 3 strand one to do the 2009 WR - all from the last little bit of that batch of 3/02.
Received on Fri Jan 08 2010 - 07:23:40 CET
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:45 CET