I know this has been addressed many time but.. on duration models, is it common to make prop hubs out of tissue tubes to set blades one at a time rather than one long spar. I know I have seen plans to make two spars then glue them together and then set the blades on. Also on balsa hubs I have seen where you stack pieces then run your wire prop shaft thru both and make a right angle with the shaft and glue. Is that OK?
Received on Tue Jun 16 2009 - 07:06:20 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:45 CET