Re: Re: VP question

From: <RLBailey_at_care4free.net>
Date: Sun, 13 May 2007 12:59:57 +0100

Bill

No jig needed - put a 0.3-0.4mm (012-016) drill in a hand held pin vice and drill by hand to make the pilot hole. Drill out by hand to the desired size. Works perfectly and much better and more controllable than a minidrill.

Bob

  ----- Original Message -----
  From: Bill Gowen
  To: Indoor_Construction_at_yahoogroups.com
  Sent: Wednesday, May 09, 2007 3:25 PM
  Subject: [Indoor_Construction] Re: VP question


  Thanks for the ideas so far. I think I can make these guys work now.
  Next I've got to put together a jig for drilling holes in the end of
  the screws.



   

[Non-text portions of this message have been removed]
Received on Sun May 13 2007 - 05:34:14 CEST