Excellent Marty!
To make the slot use a razor saw like Zona. Good to make a jog for
this as well. The one I have is 008" and the slot it cuts is perfect
for a tiny screwdriver..
Max
--- In Indoor_Construction_at_yahoogroups.com, Marty Sasaki <marty@...>
wrote:
>
> If you have access to a drill press, then making a little jig is
> really easy. Start with a piece of relatively thick material, metal,
> plastic, or a hard wood, shouldn't make much of a difference. Let's
> say it's 6mm thick. Clamp this down and then drill through with the
> small bit, say .013. Without moving anything, replace the bit and then
> drill the big hole, but only half way through. Tap the hole.
>
> Screw the screw into the large hole, then drill using the small hole
> as a guide.
>
> Marty Sasaki
>
Received on Thu May 10 2007 - 22:53:17 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:45 CET