--- In Indoor_Construction_at_yahoogroups.com, "Bill Gowen" <b.gowen@...>
wrote:
>
> Thanks for the ideas so far. I think I can make these guys work now.
> Next I've got to put together a jig for drilling holes in the end of
> the screws.
Ya didn't ask, but here's how I do that task anyway:
- I use that cheap Dremel drillpress thing to hold a Dremel with
a .013" drill bit in it (it's a nice bit - the shank flares out to fit
the largest Dremel chuck)
- The nylon screw is screwed into a threaded hole in a flat piece of
scrap plastic
- I line it up by eye and let 'er rip
Despite the relative kluge-iness of the whole thing it is pretty easy
to do and the hole gets pretty dang centered and lined up
Received on Wed May 09 2007 - 09:27:56 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:45 CET