Re: Hobbyshopper question

From: Brett Sanborn <08bdsanb_at_alma.edu>
Date: Wed, 19 Jul 2006 19:08:42 -0400

Barry,
The test is to see if the dime will pass through; if it does, then the stick is bending to the right amount. If not, the stick is bending too much. Coslick could have said "measure .050" but that would have been harder.

Brett
  ----- Original Message -----
  From: barrysholder
  To: Indoor_Construction_at_yahoogroups.com
  Sent: Wednesday, July 19, 2006 6:40 PM
  Subject: [Indoor_Construction] Hobbyshopper question


  In the instructions pertaining to the bending tests, I don't get what
  the dime with thread is for?



   

[Non-text portions of this message have been removed]
Received on Wed Jul 19 2006 - 16:16:51 CEST