Most everything Ray makes is worth the money.
----- Original Message -----
From: barrysholder
To: Indoor_Construction_at_yahoogroups.com
Sent: Thursday, May 18, 2006 2:37 PM
Subject: [Indoor_Construction] Balsa Strippers
OK here's my daily question. What's the best way to cut thin(1/32sq.)
and so forth. I have the Jones stripper but it only goes down as small
as .045. Any thinner and it might be pretty hard to push 1/32 thru w/o
distorting it. Is the Harlan stripper worth the money?
SPONSORED LINKS Aircraft Aircraft finance Aircraft financing
------------------------------------------------------------------------------
YAHOO! GROUPS LINKS
a.. Visit your group "Indoor_Construction" on the web.
b.. To unsubscribe from this group, send an email to:
Indoor_Construction-unsubscribe_at_yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
------------------------------------------------------------------------------
[Non-text portions of this message have been removed]
Received on Thu May 18 2006 - 11:47:08 CEST
This archive was generated by Yannick on Sat Dec 14 2019 - 19:13:44 CET