Re: [spam] Harlan Stripper

From: Don Slusarczyk <don5490_at_sbcglobal.net>
Date: Mon, 15 May 2006 16:44:48 -0400

barrysholder wrote:

> Has anyone had any experience with a Harlan Rubber not cutting thru
> every 3-4" after you've cut about 8-10" OK.I was told there's a couple
> of screws on the side but I'm a little concerned about messing with a
> piece of equipment like this. I have yet to get consistant
> rubber,maybe it due to this problem.

You may need more tesion between the two blades. There should be an
adjustment on the side which presses the upper cutter harder against the
lower one. Use VERY small changes, press too hard and you can warp of
crack the blades I had a similar problem with an old Polish cutter that
is about 20 years old and it was a bad spot on one of the blades, had to
buy new blades to fix the problem.

DOnn
Received on Mon May 15 2006 - 13:43:49 CEST